DT_RESYNC

Fully re-applies the session already loaded on this drawing against the current data-mapping rules. Where LOAD_DT asks you to pick a session, DT_RESYNC reads the one stamped on the drawing, asks you to confirm, and re-runs the same fill — attributes, equipment diagrams, and tables.

The ribbon's JobEngine → Drawing Tools → Resync button now runs DT_RESYNC_REVIEW, which shows a checklist before applying changes. Type DT_RESYNC only when you deliberately want the full re-apply path from the command line.

Both resync commands require a drawing that already carries a loaded session — on a fresh template, use LOAD_DT first.

When to use it

The design changed in JobEngine (wizard re-run, equipment swap, revised layout) and you want the drawing to catch up without re-picking the project, with the full apply behavior instead of the review checklist. Also the quickest way to re-fill after the mapping rules were updated by your admin.

Prerequisites

• A drawing that has had LOAD_DT run on it (it reads the session stamp LOAD_DT writes).
• Signed in.